Item Dimensions LxWxH – 27.95 x 13.78 x 0.2 inches
Item Weight – 6 Pounds
Efficiency – High Efficiency
LIGHTWEIGHT AND ULTRA – THIN FOR EASIER MOVING – This solar panel packs 110W of power yet is only 0.5inch (1.2cm) thick and weighs only 6lb (2.7kg), Foldable Dimension:21*20*1inch (54*50*2.4cm), making it easier to transport, hang, and remove.
PERFECT CHOICE FOR OUTDOOR AND EMERGENCY LIFE – 9.85ft (3m) cable length from panel to controller, For most power stations (Jackery, Goal Zero, Ecoflow, Paxcess) and 12-volt batteries(AGM, LiFePo4, Deep cycle batteries), RV, car, boat, trailer, truck, pump, camping, van, emergency power.
COMPLETE KIT, WORKS OUT OF THE BOX – Smart PWM charging Intelligent protection against reverse polarity, overcharging, short-circuit, and reverse current. Integrated 5V 2A USB ports to charge phones and USB devices. If you use the built-in MPPT Power Station, you don’t need to connect the attached PWM controller.
AFFORDABLE AND HIGH CONVERSION EFFICIENCY – With high efficient monocrystalline solar cell, you will get greater power efficiency even though the panel is smaller than a traditional model. Maximizes system output by reducing mismatch loss.
QUICK DELIVERY+WARRANTY – Amazon US warehouse shipping, Receiving goods in time， All DOKIO products come with a 30-day money-back Guarantee, 1-year warranty and forever support from DOKIO customer care.
3rd Party Product: please consider that this product is supplied by a 3rd party and you may be redirected to Amazon upon adding to cart. Your order will be processed through Amazon and everything else handled by the 3rd party seller.
This video is not intended for all audiences. What date were you born?
Adobe Flash Player is required to watch this video.
Install Flash Player
Can I connect panel to battery for charging directly without controller ?
Most of your power stations can do this.Most power stations have built-in MPPT,but batteries, without controller voltage regulation,may burn out due to overcharging.
To charge a power station with a built-in controller, do not connect PWM controller.
Why the solar can not produce 110W power when chargingto power station?
As you know the solar panels are affected by many factors . 110W is tested in an ideal laboratory. In an ideal laboratory，110 Watts at 18 Volts(The panel rated voltage) yields 6.1Amps, where I=P/V.
How to get higher power?
The panels are affected by the light and angle. The angel of the light illuminating the panel and The intensity of the light changes with the rotation of the sun.
Please try test panel under the full sunlight, make sure there is no shadow cast.
Are this units waterproof ? Can these solar panels be permanently instaled outside?
Yes,lt is waterproof , BUT meant for temporary or emergency use only. Not designed for permanent installation or prolong weather exposure,DON’T leave them out at night or in bad weather.
What is the difference between PWM controller and MTTP controller?
Using without batteries is primarily providing power to the USB ports(PWM controller). If you want higher power, you can buy MPPT and use it.Charge controllers reduce the wattages and amperage output as the batteries approach getting full.